Industrial Battery Charger
We manufacture battery charger for heavy-duty use as per the customer's requirement. Our charger uses latest state of art of micro-controller technology to achieve efficient and proper battery charging. Our strength of production is from small single-phase battery charger to 3 phase heavy charger with high ampere and voltage. Our chargers are already working in various places for Electrical substation, Electric vehicle battery charging, Initial plate building of battery and many more. Where simple charger cannot function.

FEATURES:

LCD display shows all status with audio alarm on fault.
Over current protection. (OVER LOAD)
Short circuit protection.
Reverse batt.  Protection by fuse.
Battery over charge protection.
CCCV charging.
IBM (Internal Battery management) topology used for charging.
Under/over mains charging cut off.
Soft charger start.
Charging on delay.
Input Phase control topology.
Ripple less than 1%
PWM charging.
LCD DIGITAL DISPLAY to provided to monitor.

LCD STATUS:

liquid crystal display with back lite.
Company name
Product name
Mains voltage in VOLT
Battery voltage in VOLT
Charging current in AMP
Charging mode (Boost, Normal, Optimize mode)
Auto equalizer mode after every 28 days.

FAULT:

• Mains low
• Mains high
• Mains fail
• over load
• Short ckt.
• Fuse blown
• MCB trip
  All fault display on LCD through self diagnostic soft ware.

Typical Features of three-phase battery charger

• Input voltage 400V ±15% 50 Hz
• Output voltage 48V/110V
• Output current 30A/50A/70A/100A or as required
• Load DCDB with breaker as required
• Diode drop facility as required
• Fully programmable by user for various parameters.
• Automatic periodic equalization as programmed.
• Low ripple on output.
• Self-diagnostic for various internal faults.
• IP51 housing